Fuel line replacement

[Duster1]

Morning All,
Firstly a Happy New Year to everyone and your families.
I’m looking at replacing the fuel line on our 72 Duster. Could someone point me in the right direction as to what to use, whether it be solid or flexible and what are your preferred choices.
Andy

[Pete]

Hi there, it depends a lot on the application and engine size.
For a standard engine and road use a solid line 5/16" with suitable flexi E5 / E10 compatible tubing should suffice.

For a Racing application, I would recommend larger bore and possibly Teflon lined braided hose.

[Blue]

Assuming you are just wanting to replace the original, a roll of 5/16” Kunifer from eBay will do the trick. Also assuming you will be replicating the torturous route of the original line, a small hand held bender will help. You’ll need your glamorous assistant as wrangling 20ft of bent line that wants to get caught on everything is always entertaining..

[Duster1]

Hi Chaps,
Maybe in the future we may look at going down the route of installing EFI. So want to make sure that what we do is more than adequate to accommodate a fuel pump, etc.

[Blue]

You would need to look at what your chosen EFI system needed for fuel delivery, it might also want a return line. Some systems need a swirl pot and an in tank pump. When I looked at it it all gets very expensive and I really don’t see the benefit over a good carb and a decent tune up, your choice.

[mopar_mark]

Fuel supply is dependant in engine needs, as said you need to check on chosen EFI requirement. As a minimum for EFI, I would be looking at 3/8” supply & return.

I actually had to increase my return line size, as it was becoming a restrictor and took over from the regulator. That said, I have a long run from tank to engine & my engine is not in the normal bracket. ie my supply is 5/8”, 3/4” return.

It’s a fact that a well set up Carb can outperform EFI, assuming all parameters are equal. It’s when those parameters change, EFI can have an advantage. Trust me, when trouble shooting, there’s nothing easier than looking down a carb to confirm you have fuel or checking Dizzy for spark.
Laptops have there advantages for sure & once you understand ECU you have multitudes of tuning opportunities….

At the end of the day, what is your end goal

Edit: Not sure of what EFI, but Fitec would never get in my list of choices. I know quite a few folks who have tried, but eventually removed as troublesome

[Duster1]

Thanks for the replies.
After discussion we decided to opt out of going down the EFI route.
So my next question is about installing an electric fuel pump and regulator. What’s best
Also what style of phenolic spacer should we go with on a dual plane intake with a Holley 4160.

[Pete]

A Holley "Blue" pump will be fine, the push as opposed to pull, so will be mounted at the rear near the tank - I would advise putting a replaceable Filter twixt tank and Pump.

Holley Small regulator near the Carburettor. You will get away with dead heading, but you can run a return line if you wish.

You can get the pump and Regulator as a kit.

I assume this is a Small Block?


Good call on ducking the EFI....

[Blue]

4 hole spacer on a dual plane intake. Think about this one, unless you are planning 500hp and 10 second quarter mile passes you really don’t need an electric pump. 3/8” sender and line, Carter competition or Edelbrock mechanical fuel pump with a small Holley regulator will get the job done, is practically bolt on and will give years of trouble free service. You’ll need a pressure gauge and a 3/8” filter before the carb. On the other hand a Holley blue electric pump would do the job but you will find it difficult to mount it at the rear where it needs to go with a stock tank. They are very noisy and not especially reliable especially when a car is laid up over the winter. A Holley black pump is quiet if mounted correctly but is best part of £500. Your choice, I’ve only just fitted an electric pump as I’d found the limits of a mechanical set up as I’ve gone faster, I was more than happy with it up to that point. I should add that apart from now having 5psi fuel pressure, going electric has made not a jot of difference performance wise for the best part of a £1000 outlay.