Stroker rebuild

[Mossy68]

Out of interest. How much are honing tools ??

You can get cheap 3 legged ones for less than 20 quid or a flexi hone for quit a bit more but much better.

Only ever seen the 3 legged type. All interesting stuff.

[Carl]

FFS get it done professionally and not with a hand tool.....

I think it was about £120 for a V8 hone last year........

I could do but quit fancied doing it myself, if the flex hone tools work out more then I probably will, no harm getting a price I guess.

[Pete]

None of my business, but do you think you can get all 8 bores parallel and to the same specification by hand?

You have had quite a narrow escape so far, I would not tempt fate.

My $.10 and I will comment no more............

[Carl]

Out of interest. How much are honing tools ??

You can get cheap 3 legged ones for less than 20 quid or a flexi hone for quit a bit more but much better.

Only ever seen the 3 legged type. All interesting stuff.

[Mossy68]

Yeah. Just looked them up Carl. Never seen them before. Look effective

[mopar_mark]

Flexi hones work without question, but there more intended for breaking up/deglazing a good parallel bore.

Ditto to Pete's advice.

Spend your money getting it done professionally. This is really not a time you should be considering DIY...

[Adrian Worman]

None of my business, but do you think you can get all 8 bores parallel and to the same specification by hand?

You have had quite a narrow escape so far, I would not tempt fate.

My $.10 and I will comment no more............

Exactly right Pete, you'll never keep the bores the same size, or square, or even match the correct cross hatch pattern.

Take it to a machine shop and get it measured and honed proffesionally Carl.
Even a bore and hone is usually only a couple of hundred quid, and the measuring will be included in that of course.

You want it right first time mate

[Carl]

None of my business, but do you think you can get all 8 bores parallel and to the same specification by hand?

You have had quite a narrow escape so far, I would not tempt fate.

My $.10 and I will comment no more............

The tools are slightly over bore size so the same tension is always there and its all to do with rpm x stroke speed x duration as long as that's the same for each bore there isn't much of a problem, its only really a de glaze not a re bore only takes about a thou off so wont make that much of a difference to the bore specs

[Dave-R]

I would advise getting it done professionally too.

But if I am really honest I know I would do it myself.

Maybe I shouldn't have said that. But being honest is my thing.

[Les Szabo]

Carl you've been given a second chance as I said earlier......don't take any more chances........it goes without saying to get it done properly, it doesn't have to be a race engine to put it together properly.




Les

[Dave-R]

It is taking off an even amount along the whole length of the bore that is the tricky bit.

[Carl]

Okay I can see im not gonna win this one

[Les Szabo]

Not a case of winning, we are all just offering our opnions on this, you gotta do what you gotta do, there's just certain things we don't do that we could ourselves when it comes to engines if we want a good seal.
I would certainly get those pistons checked properly before you start to do anything as well as anything you do will depend on thier exact sizes. And if your financies run to that cam you wanted, now would be the time to do it...you'll have a stomping BB eater!!

Les

[Carl]

Fair point guys I take your advice on board, it will be done by the professionals. The price of a Flex Hone is near on 100 quid anyway and as you say im at last chance saloon with this block.

[Les Szabo]