Page 2 of 2
Posted: Wed May 20, 15 8:30 am
by autofetish
It's 8/10ft further back ( see concrete pads)
Mick you might have to change that rear gear set now
Posted: Wed May 20, 15 9:59 am
by Mick
RobTwin wrote:I was assuming they were going to move the new one into the same position as the old once the old one had been removed but they seemed to skip a bit on the video so it wasn't clear whether they did or not
That's what i was looking for Rob.
4.30's should do it Will.
Posted: Wed May 20, 15 10:34 am
by Carl
Everyone will now be half a second quicker
Posted: Wed May 20, 15 11:34 am
by autofetish
Carl wrote:Everyone will now be half a second quicker
Slower
Posted: Wed May 20, 15 1:26 pm
by Dave999
Mick wrote:DaveBishop wrote:Mick only if they have moved the finish timing sensors
Yes but the gantry signifies the finish line.
thats good then
you think "i've finished" 8 to 10 feet after you actually did.
if it was the other way there'd be people lifting off the gas before the timing beam.
only a problem if you are timing yourself i guess..... and that that speed you shouldn't be dicking about with ya watch
dave
Posted: Wed May 20, 15 2:38 pm
by Carl
autofetish wrote:Carl wrote:Everyone will now be half a second quicker
Slower
No if the finish line is closer to the start line, it wont take as long to go past the finish line so their times will be half a second quicker.
Posted: Wed May 20, 15 3:39 pm
by Dave999
but they built the new gantry behind the finish line
Posted: Thu May 21, 15 9:27 am
by Carl
I knew that, I was just testing
Posted: Fri May 22, 15 11:35 pm
by Cuda Commando
Went to the pod last weekend with the Doomsday Impala team.New gantry looked great.We had a walk to the end of the return road and the old gantry is laid down by the side of it.It looked rough.
Posted: Sat May 23, 15 5:45 am
by Pete