Mopar Muscle Association UK

Posted: **Thu Feb 25, 21 12:05 am**

Thanks for the replies and comments

Ended up having to rebuild the whole of the inner wing before even getting to the outer skin.

Good enough for a skim of filler

: 20210220_125709.jpg (140.95 KiB) Viewed 1057 times

Repair on the other side started with the rotten spare wheel well - but that of course grew! Ended up deleting the daft bit of the well that sits below the wing bottom.

I may post some more horror photos as I was allowed the use of the grinder again this afternoon

: 20210223_152936.jpg (109.1 KiB) Viewed 1057 times

Posted: **Thu Feb 25, 21 6:53 am**

Have you got one of these ?

Very useful tool

https://www.ebay.co.uk/i/293441258555?c ... gJVEPD_BwE

Posted: **Thu Feb 25, 21 9:22 pm**

I have got one, and a roller version as well, but tend to prefer butt welding where I can. I'm less worried about using filler on the Plymouth, as it's a driver and will never win a concours class

As long as the rust has gone.....

Look away now.....

: 20210224_125336.jpg (149.4 KiB) Viewed 1040 times

: 20210224_123107.jpg (136.43 KiB) Viewed 1040 times

Posted: **Wed Apr 14, 21 8:44 pm**

Some more polishing, and ready to go back on. I'd call it a six-footer as I had some paint reactions (I do spray in pretty bad conditions

) You can't see them in the photo - that's just dodgy shadows! Considering how rotten it was, overall pleased with the outcome.

Motor, mechanism and wiring all refurbed, and finally have the electric rear lock working

Now just to finish all the door shuts, the doors, the rear of the roof, the rear lower wings, sills, lower front wings, headlining, rear wiring.....

: 20210412_151147.jpg (99.07 KiB) Viewed 1008 times

: 20201112_144657.jpg (148.3 KiB) Viewed 1008 times

: 20201112_151029.jpg (157.6 KiB) Viewed 1008 times

Posted: **Wed Apr 14, 21 10:07 pm**

go to the top of the class and get your gold star

neil.

Posted: **Thu Apr 15, 21 7:25 am**

That looks real good job so well done

Posted: **Thu Apr 15, 21 10:40 am**

Nice bit of work

Posted: **Thu Apr 15, 21 6:58 pm**

Amazing great work.

I always use this on all the bits inside

amazing work

https://cpc.farnell.com/loctite/8781006 ... FTEALw_wcB

Mopar Muscle Association UK

Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)

Re: Rust Repair Fuelled by Ale :)