Mopar Muscle Association UK

Glad you said that Clive. Thanks.

Good job Dave , keep @ it.

I might take that headlight out and see if I can stretch the metal around the opening with the bezel fixed in place.

All folk will be seeing is tail-lights anyway, Dave....

Em, I hope they are straight

Bit of the Ol tiger seal behind that Dave after repairing the hole, job done
Nobody will notice if you didnt

the fit looks fine dave but you gotta get a pukka screw in there, that is one thing i hate when the bodgers stick any old woodscrew in etc
looks naff

Cannonball wrote:the fit looks fine dave but you gotta get a pukka screw in there,

Yeah I will take care of that no worries. But couldn't be bothered to go out to get paint today so tidied up a few other things instead. Fitted bits of trim etc.

One thing I did do was make a little ally box for the 5 volt power supply I made to power the MAP sensor I have fitted on the intake. I have fixed the box up under the dash out of sight.

I also ran wires for the LM-1 recorder meter under the center console so that the meter can sit in the console box when recording during a run.
It will be recording air/fuel ratio, RPM, and manifold vacuum and the software will plot those together on a graph. I am going to try and blag one of our old laptops from work to display the results at the track.

I ran an audio jack cable for an ipod into the console box too.

Almost forgot. I got the console top to fit flush around the shifter as well.

top job on that that shifter dave, is it sat on the original slap stick mount? i gather you cut some of the ally casing on the shifter cover to raise it ?

There are a LOT of mods to the shifter cover to be honest.

so is it sat on the original mount or not? im looking to change mine at some point so info would be of help, hence why i ask

Oh sorry. I welded in a base plate for the shifter. Had to do some minor cutting of the stock metalwork.

thanks mate, looks like its a lot less hassle fitting a hurst quarter stick than say a b&m unit

Very neat Dave looks similar to AllKillers cuda

We're hoping the Hurst ProMatic we bought last weekend will fit under our stock console. The shifter's certainly lower-profile but the console maybe higher too.

Looking excellent Dave, the headlamp alignment is hardly noticeable and once the pukka screw is in there, it will look great.