Propshaft UJ replacement
Posted: Sun Nov 08, 26 3:33 pm
Afternoon all,
Going to replace the UJs on my Polara soon. It's not a job I have done before but have watched numerous detailed videos so feel prepared to have a go.
Was wondering if there are any recommended 'dos and donts' from experience?? Anything else I should do as a matter of course when the prop shaft is off (I've ordered an output seal for the 727 if needed).
I plan on refreshing and painting stuff while it's off with POR15. I will also mark the position of everything relative to everything else but not sure if this is necessary when replacing the UJs?
Thanks in advance for any advice,
Cheers Steve
Going to replace the UJs on my Polara soon. It's not a job I have done before but have watched numerous detailed videos so feel prepared to have a go.
Was wondering if there are any recommended 'dos and donts' from experience?? Anything else I should do as a matter of course when the prop shaft is off (I've ordered an output seal for the 727 if needed).
I plan on refreshing and painting stuff while it's off with POR15. I will also mark the position of everything relative to everything else but not sure if this is necessary when replacing the UJs?
Thanks in advance for any advice,
Cheers Steve