Mopar Muscle Association UK

Ah, as my ol dad used to say you get nothin for nothin!!
Luckily none of the gauges work, i have no interior light or dash lights and the stereo packed in last week so it should all balance out?

I'm about to plumb a 383 rad into my Rover 3.5 powered D100, have tracked down twin Cossie fans( hold em above your head an they almost lift you off the ground! !) Only thing left is a switch- any recommendations? I like the plumbed-in type but 50 quid!

I've had problems like this caused by frayed engine earth cables, a corroded batt terminal which be fine til you went on a run then would cause loss of power as the corrosion caused high resistance, meaning the batt would charge but not enough to rev properly! :x ! I would take each major connection...

Ah, yes my D100 pickup ran a 'wet' servo for a while, quite exciting!!!

Think i have some somewhere if ya stuck i'll try an root em out- Needed one years ago when i had an Aus Charger an as they had to order em in special like they'd only sell me 10 !!

Dumb question No.268 : do the 318/340/360 all start life as the same casting? also are there any 'heavy duty' or race castings and what would i look for if i was to build a blown smallblock, for example?

I've had lean-burn overheating caused by inlet manifold leaking, took a l o n g time to suss that one! It was only misfiring under load so tweaking mixture/ timing had no effect til i drove it uphill, then it wheezed to a halt. Finally struggled an spluttered to a garage, they diagnosed it in about ...

Idiots guide to wheel sizes / offset, etc...... http://www.tyres-online.co.uk/techinfo/alloy.asp Looks jolly useful to me :idea: Although it appears from Summit Racings page..... http://www.streetandstripmotorsports.com/charts_guides/charts_backspacing.htm that 'backspacing' is measured very differe...

.....and the blower .....

I've a Capri caliper on ebay at the mo, only 1 unfortunately... if you want it let me know and i'll pull the auction:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... %3AIT&rd=1

Only experience i have of rechroming was a load of bike bits i had ruined by a place that happily shut down shortly after! They polished a chainguard so thin they wore a hole through it. When i tightened a bolt on one part a 1" circle of chrome twisted off like a washer & the rest then peel...