My connector and wiring got a bit frazzled in the fire, the motor seems ok though.
Anyone got a connector with or without wiring? The bulkhead side of the connector would be great too.
WANTED- B body wiper motor wiring/ connector
Moderator: Moderators
WANTED- B body wiper motor wiring/ connector
- Attachments
-
- Wiper motor connector.jpg (83.55 KiB) Viewed 1160 times
-
- Wiper motor wiring.jpg (77.22 KiB) Viewed 1160 times
No-one will believe you...
Re: WANTED- B body wiper motor wiring/ connector
Have you considered bypassing the block and just hardwiring both looms together? I would, cuts out the connection completely
Bat Girl Stalker Living Petes Dream
Re: WANTED- B body wiper motor wiring/ connector
I'll probably have to now Steve, i just liked the look of the original
No-one will believe you...
Re: WANTED- B body wiper motor wiring/ connector
NOS
here
https://www.ebay.co.uk/itm/NEW-66-76-Pl ... ctupt=true
All 3 both sides ...
bit spendy but Nice
Dave
here
https://www.ebay.co.uk/itm/NEW-66-76-Pl ... ctupt=true
All 3 both sides ...
bit spendy but Nice
Dave
The Greater Knapweed near the Mugwort by the Buckthorn tree is dying
Re: WANTED- B body wiper motor wiring/ connector
Strewth £100!
Thanks Dave but I don't think I need it that badly
Thanks Dave but I don't think I need it that badly
No-one will believe you...
Re: WANTED- B body wiper motor wiring/ connector
yeah i know
ridiculous init
but it is nice and new...
however
I think you need 3 durite 6 way spade connectors in male and female
the durite brand can be bolted down with tiny bolts or riveted ...see the little indents
take your current bulkhead connector
use a grinder to take off the current males
use small bolts to mount up the Durite males in place
put females on ends of wires
good as new but white
costs about 6 quid + time and a filed down electricians screw driver for pinging connector tags +lots of jam jar labels and a pen
mask off spray the lot black
nobody knows
Dave
ridiculous init
but it is nice and new...
however
I think you need 3 durite 6 way spade connectors in male and female
the durite brand can be bolted down with tiny bolts or riveted ...see the little indents
take your current bulkhead connector
use a grinder to take off the current males
use small bolts to mount up the Durite males in place
put females on ends of wires
good as new but white
costs about 6 quid + time and a filed down electricians screw driver for pinging connector tags +lots of jam jar labels and a pen
mask off spray the lot black
nobody knows
Dave
The Greater Knapweed near the Mugwort by the Buckthorn tree is dying
Re: WANTED- B body wiper motor wiring/ connector
You can keep original looking if you very carefully drill out the relative holes in the connector and run each wire through its designated hole. Bit fiddly but a decent 'last resort' if needed. Good luck with this project
Cheers Steve
Bat Girl Stalker Living Petes Dream