Page 1 of 1
Fuel tank pad
Posted: Thu Apr 01, 21 5:27 pm
by ScottyDave
Hi all, a question for those of you who have replaced your fuel tanks, what have you used as a Pad/Insulator between the tank and the boot/trunk floor? I'm trying to collect everything together before the next trip North
Re: Fuel tank pad
Posted: Sun Apr 04, 21 12:15 pm
by MattH
I just used rubber strip, I think it was ribbed rubber flooring mat. I wouldnt use anything that holds water, like those horsehair sound pads.
Re: Fuel tank pad
Posted: Sun Apr 04, 21 1:55 pm
by ScottyDave
Cheers Matt
Re: Fuel tank pad
Posted: Wed Apr 07, 21 10:50 pm
by kma176
I used Dynamat seems to do the job OK !!
Re: Fuel tank pad
Posted: Wed Apr 07, 21 11:26 pm
by ScottyDave
kma176 wrote: ↑Wed Apr 07, 21 10:50 pm
I used Dynamat seems to do the job OK !!
I had thought about that thanks
, originally I think its tar-paper.
Re: Fuel tank pad
Posted: Thu Apr 08, 21 4:21 pm
by Charger
Re: Fuel tank pad
Posted: Fri Apr 09, 21 12:21 pm
by Faux-7-0
I'm holding a couple of old cushioned vinyl floor tiles for this purpose when the tank is installed in the Challenger.
Re: Fuel tank pad
Posted: Fri Apr 09, 21 8:36 pm
by ScottyDave
Lots of great ideas
Re: Fuel tank pad
Posted: Tue Apr 20, 21 7:29 am
by Steve
I used rubber matting too. I found some very fine ribbed good quality stuff from a Land Rover specialist at a Military show in Malvern. It wasnt expensive and was great quality. I think it's for floor matting in old Land Rovers,
Cheers Steve