Si's '70 Charger 500
Moderator: Moderators
Next mod ... just had to get shut of the Cali tail pipes. The new tails are s/steel 3”dia with a 2.25”ID inlet. Had to add a short length of 2.25” pipe to the tails to get them to protrude out far enough from under the car after cutting the droopy bit off. Have used the rear hanger u-bolts to clamp the tails on pics ...
Last edited by Charger on Thu May 07, 15 10:58 pm, edited 2 times in total.
Si
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
Nice Simon i have some awesome tips for my Duster they came of DemonGs prize winning Dodge Demon so as you would expect they are good and not repos just need to get them fitted i am also going to order some from Year one for the Roadrunner they have Red stripes on them wich i will paint Blue to match the paint work.
- Rogue Trooper
- Posts: 1792
- Joined: Wed Feb 01, 06 8:19 pm
Great Looking car...
Cool colour...gives the car its character...
Richard.
Richard.
At my Worst,I'm at my Best ......
072
072
Bucks Charger wrote:Cool colour...gives the car its character...
Richard.
thanks guys!!Clivey wrote:Cracking motor Simes (but then I would say that )
yeah, wasn’t sure what to do with all that when the tank went back up after the trunk floor was done, do those 4 pipes need to be connected or can they be capped off?? The gas tank vents thro the filler cap right?? The gizmo in the trunk that looks like a piece of scaffold tube is present, and there’s a fifth pipe that runs forward (following the same path as the fuel pipe) to the engine bay, where it is capped off!! So I guess the ECS is present but not connected to anything?? Can all the redundant plumbing be removed??Clivey wrote:I see you have the evaporation control system fitted mate
I’m probably going to need a new gas tank sometime in the future, I noticed when it was off that the top side is quite rusty and it must be getting a bit thin!! I’ve seen replacement gas tanks listed with and without connections for the ECS, I guess I could get one without the connections if the ECS isn’t connected to anything up front??
Si
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
just had my seats retrimmed, picked them up from DM’s this morning, cheers Dave, great job . that’s me busy at the weekend then …
Si
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
refurbished seats in , covers from WASP, retrimmed at Dave Madders emporium, pics …
Last edited by Charger on Thu May 07, 15 10:59 pm, edited 2 times in total.
Si
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
passenger door mirror fitted , purchased from http://www.pgclassic.com/ , what these photos don’t convey is that I checked the position of the screw/bolt holes by measuring off of the driver side about 75,432 times, as the saying goes, measure 75,432 times, drill once!! pics …
Last edited by Charger on Thu May 07, 15 11:01 pm, edited 2 times in total.
Si
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/
1970 Charger 500
383 | 4bbl | 727 column | PAS | PAB | buckets/buddy - check out my photos HERE
If you don't want another same old brand-new car ... you could be DODGE MATERIAL
1970 Dodge Charger Registry - https://www.1970chargerregistry.com/