http://board.moparts.org/ubbthreads/sho ... n=0&page=0
odd blower set up
Moderator: Moderators
dunno
my guess is its a gear setup
blower sits too far back....but has to otherwise
1) manifold would have unequal lengths to all cylinders..central at least pairs them up
2) to make that hole in the hood you'd need to avoid main support bars
bring it too far forward and you'd have to cut them.
and as one poster points out...no it doesn't have its own exhaust header...thats just where they go on a 6
my guess is its a gear setup
blower sits too far back....but has to otherwise
1) manifold would have unequal lengths to all cylinders..central at least pairs them up
2) to make that hole in the hood you'd need to avoid main support bars
bring it too far forward and you'd have to cut them.
and as one poster points out...no it doesn't have its own exhaust header...thats just where they go on a 6
The Greater Knapweed near the Mugwort by the Buckthorn tree is dying
its an aussie car
more likely the former rather than the latter
its not mad max ya know
could be one of those units used on those big diesles that have a blower and a turbo
spin the blower fast on tickover and cranking to get the stuff to ignite and then gear it down or out of the equation as the turbo kicks in.
Dave
more likely the former rather than the latter
its not mad max ya know
could be one of those units used on those big diesles that have a blower and a turbo
spin the blower fast on tickover and cranking to get the stuff to ignite and then gear it down or out of the equation as the turbo kicks in.
Dave
The Greater Knapweed near the Mugwort by the Buckthorn tree is dying