DONT BUY !! Mr Gasket Fabricated Aluminum Valve Covers

[TIB3300]

Mr Gasket Fabricated Aluminum Valve Covers

After a long search I went for these

https://www.jegs.com/i/Mr-Gasket/720/6860G/10002/-1

Mr Gasket Fabricated Aluminum Valve Covers 1964-1991 Small Block Chrysler 273-360
Part Number: 720-6860G From JEGS

sfavafdbwgh.jpg (26.13 KiB) Viewed 17494 times

Warning don't buy them

These were only fitted in May this year and done less than a 1000mls , all the screws were too long bottoming out in the head, also had to work on the mounting surfaces to to make them flat. That I can deal with for cheap cheesiness covers.

But whats done me is the cracks in the welding around the screw holes on the top, causing a small but annoying oil leak.
Contacted JEGS via live chat with JEGS Only to be told you only get a
3 MONTH WARRANTY ON FAULTS AND MANUFACTURING . Makes me think they know how long these could last before something goes wrong with them

So with taxes and shipping that's £300 i aint getting back, they look great but be warned stay away from these.

[Dave999]

if they are polished not chromed on the inside
some of that aluminium solder rod, (you see on facebook) and a blow torch can fix it

used it on Lambretta head sets and chain case to seal or build up and provided you don't completly collapse your aluminium casting due to too much heat all good

need a starinless steel brush, no other type works, to prep surface, to remove the natural oxide coating on aluminim and then its much like a cross between brazing and gas welding. heat surface and let rod melt and pool from that heat
brush and do the job
leave it too long and you need to brush..... it again

Dave

[Dave999]

https://www.ebay.co.uk/itm/304546520858

[TIB3300]

Thanks Dave
The repair isn’t the issue as I can reweld them easily enough, it’s that it will burn and the coating off them

[mygasser]

Thanks Dave
The repair isn’t the issue as I can reweld them easily enough, it’s that it will burn and the coating off them

it's fine, anyone asks just tell them it's 'patina'
neil.

[TIB3300]

Thanks Dave
The repair isn’t the issue as I can reweld them easily enough, it’s that it will burn and the coating off them

it's fine, anyone asks just tell them it's 'patina'
neil.

Patinas not really the look I was going for under the bonnet Neil

https://youtu.be/N5RrYkZ2ak0

[mygasser]

Patinas not really the look I was going for under the bonnet Neil
[/quote]

i know mate, i was joshing with you
neil.

[TIB3300]

Patinas not really the look I was going for under the bonnet Neil

i know mate, i was joshing with you
neil.
[/quote]

Ah!! humor on forums using the written word

Sometimes lost in facial expressions

[mygasser]

Patinas not really the look I was going for under the bonnet Neil

i know mate, i was joshing with you
neil.

Ah!! humor on forums using the written word

Sometimes lost in facial expressions
[/quote]
i know mate, that's why i didn't say ''you were a tart'' so couldn't do 'patina' (that's a winking face and a grinning face, lol).
neil.