Re: Blue's Valiant
Posted: Thu Oct 17, 19 10:53 am
Very much like decorating apart from nothings flat, there are sharp edges, surface rust, grease, dirt and underseal to deal with. Mind you I’ve been in a few houses like that....
Mopar Muscle Association UK
The premier Mopar club in Europe!
https://www.moparuk.com/forums/
Used to be Blue's Valiant
Page 74 of 83
Re: Blue's Valiant
Posted: Thu Oct 17, 19 10:20 pm
We have this to tackle on Mandie's 57 Chevy Truck. I won't let her see these comments!!
Re: Blue's Valiant
Posted: Tue Nov 05, 19 6:57 pm
This is dragging on a bit but I'm now in primer...
Re: Blue's Valiant
Posted: Tue Nov 05, 19 7:55 pm
over the worst bit then... looks bang tidy!
Re: Blue's Valiant
Posted: Thu Nov 07, 19 5:05 pm
As Spandau Ballet would put it, GOLD!
Re: Blue's Valiant
Posted: Thu Nov 07, 19 6:21 pm
Looking good mate, is that after the laquer.
Re: Blue's Valiant
Posted: Thu Nov 07, 19 6:42 pm
Great colour, is it the light or is that like Aztec gold (a greeny gold from memory)?
Neil.
Neil.
Re: Blue's Valiant
Posted: Thu Nov 07, 19 7:06 pm
It does have a green tinge to it but not as much as it looks like in the photo.
Re: Blue's Valiant
Posted: Thu Nov 07, 19 10:04 pm
Either way it's a very nice colour 
Re: Blue's Valiant
Posted: Thu Nov 07, 19 11:20 pm
Proper colour. Nice work Blue 
Re: Blue's Valiant
Posted: Fri Nov 08, 19 7:54 am
Mmm, like that
Re: Blue's Valiant
Posted: Fri Nov 08, 19 9:04 am
Lush!
Is that cellulose or 2 pack?
Is that cellulose or 2 pack?
Re: Blue's Valiant
Posted: Fri Nov 08, 19 11:18 am
Its 2 pack using Screwfixes finest £34 gun...
Re: Blue's Valiant
Posted: Sun Nov 10, 19 9:02 am
Re: Blue's Valiant
Posted: Mon Nov 25, 19 6:24 pm
The great American aftermarket strikes again. Clocking the quick time bellhousing centre bore before final engine installation. I'm checking that when installed the transmission input shaft will be in line with the crank centre line, any more than .005" off will result in clutch and or bearing problems. Offset mounting dowels are available to move the housing to correct misalignment, but this is too far out for that option. Hopefully Trev D will be able to make an offset centre bore adaptor otherwise a new and expesive component is basically scrap.