Page 1 of 1
Ohm my gawd....
Posted: Sat Jan 29, 05 1:31 pm
by Blue
Right then, I need a little help here from someone a bit more intelligent than me when it comes to electrickery! Here's my problem, I have a VDO sender unit in my fuel cell and a Stewart Warner fuel level gauge, I don't know the Ohm rating of either component so I need to test them, how do I do that? I'm expecting the sender to be wrong so I need a figure for the gauge to stand a chance of finding the right sender.
Posted: Sat Jan 29, 05 6:17 pm
by Anonymous
Posted: Sun Jan 30, 05 10:31 am
by Blue
Cheers Wildman! Yes that does help, I can check the sender with that info, and I guess I can Check the gauge the same way by moving the float and checking how many ohms it needs to make the gauge read full or empty, Nice one!
Posted: Sun Jan 30, 05 10:52 am
by Kev
HandyDandy link there, WildMan! You're good for something, then
Posted: Sun Jan 30, 05 11:05 am
by Anonymous
I shan't glorify that with a response kev.
DAM IT !
I just did.
Posted: Sun Jan 30, 05 11:08 am
by Kev