Page 1 of 1
Could any of you machine this?
Posted: Sat Dec 12, 20 4:39 pm
by Blue
I know there's a few of you on here have machining skills, would any of you be able to machine a 727 case to take a repair bearing? Trev D can't fit it in his milling machine.
Re: Could any of you machine this?
Posted: Sat Dec 12, 20 5:26 pm
by ScottyDave
My money's on Will
Re: Could any of you machine this?
Posted: Sat Dec 12, 20 6:30 pm
by Pete
I am not a machinist, but can't you do it from the other side with a Boring bar?
You would have to draw the cutter onto the Workpiece as opposed to pushing down as per normal...
Re: Could any of you machine this?
Posted: Sat Dec 12, 20 7:16 pm
by Blue
I did wonder if that was possible, I'll be guided by those that know!
Re: Could any of you machine this?
Posted: Sat Dec 12, 20 9:55 pm
by mopar_mark
Pete wrote: ↑Sat Dec 12, 20 6:30 pm
I am not a machinist, but can't you do it from the other side with a Boring bar?
You would have to draw the cutter onto the Workpiece as opposed to pushing down as per normal...
Not sure if I would still have access to the boring head to make adjustment, if I did from the other side. I’ll have another look, think.
I know Roger (Luty) had someone machine Jerry’s 727 for something similar. as Roger couldn’t do it on his Bridgeport, it might be worth dropping him a line.
Re: Could any of you machine this?
Posted: Sun Dec 13, 20 12:52 pm
by morgan
ScottyDave wrote: ↑Sat Dec 12, 20 5:26 pm
My money's on Will
Re: Could any of you machine this?
Posted: Sun Jan 17, 21 4:55 pm
by autofetish
Sorry I’ve just seen this.
Give me a ring if you’re still stuck