Page 1 of 1
Bbody Upper control arm mount
Posted: Wed Apr 07, 21 10:07 am
by Matt74
Does anyone know how thick the upper control arm mounts are on a bbody? I need to make some new ones.
Cheers.
Re: Bbody Upper control arm mount
Posted: Wed Apr 07, 21 10:19 am
by morgan
Do you mean the plate with a 90deg bend at each end for the UCAs to mount ?
Happy to go measure mine if you want ?
Re: Bbody Upper control arm mount
Posted: Wed Apr 07, 21 1:02 pm
by Matt74
That's it Morgan and yes please if it isn't too much trouble. Don't worry if you have to jack the car up and take the wheel off etc!
Re: Bbody Upper control arm mount
Posted: Wed Apr 07, 21 4:36 pm
by morgan
Not a problem. On it...
Re: Bbody Upper control arm mount
Posted: Wed Apr 07, 21 6:41 pm
by morgan
Apologies for the delay. As usual it turned into a bigger pain than it should have been (not your fault; couldnt get battery out of micrometer!)
Right -
Pics 1 and 2 - The mounting seems to be double skinned at the bush mount. Far as I can see its the same but doubled over. I measured only one thickness. It looks to be (allowing for a little fudge) 1/8".
Its tricky to measure as metal is a bit wibbly and there is underseal etc BUT hopefully good enough for you to assess what thickness.
Measurements taken at A and B in both mm and thou".
Pics3+4 - A
Pics 5+6 - B
Hopefully clear as mud...
Let me know.
PS - I have left her jacked up and wheel off so let me know if you need any others. Otherwise I will reassemble.
Re: Bbody Upper control arm mount
Posted: Wed Apr 07, 21 6:54 pm
by Matt74
That's great Morgan. Thanks for going out of your way to help.
Allowing for the underseal I think they must be 3mm thick so I'll order some material and get fabbin'.
Thanks again