Page 3 of 3
Re: Carburettor advice
Posted: Mon Nov 29, 21 5:33 pm
by Dave999
and i'l, happily say if its a carb configured OEM for a pontiac you'd be spending a lot to get it near what you need
more than just jets rods and springs i'd suggest
good job you looked it up....
its an OEM carb, pontentially year specific, not as easy to configure as a universal fit aftermarket version , or indeed a mopar one off a similar sized engine of similar vintage
Dave
Re: Carburettor advice
Posted: Mon Nov 29, 21 7:45 pm
by morgan
OR .... just sayin'.... you *could*....
Re: Carburettor advice
Posted: Thu Dec 02, 21 9:23 pm
by colinhammond04
Put one on my 360 charger easy install started first time ,well happy with it
Re: Carburettor advice
Posted: Fri Dec 03, 21 11:34 am
by Dave999
EFIhardware tower of power needs a big hole in the bonnet
Re: Carburettor advice
Posted: Sat Dec 04, 21 7:01 am
by morgan
Dave999 wrote: ↑Fri Dec 03, 21 11:34 am
EFIhardware tower of power needs a big hole in the bonnet
Do you break out your glove of love when installing a tower of power Dave ?
Re: Carburettor advice
Posted: Mon Dec 06, 21 9:54 am
by Dave999
Its mandatory
sez so in the distructions...
I find it hard to image who would want an 8 inch stack with the injectors at the top sticking through the bonnet of their Holden Gemini
look better if you had 2
blower and big scoop.... avoid low bridges
https://www.efihardware.com/products/18 ... r-of-Power only $7K AUD
new holley is probably the best bet
Dave