727 rebuilding jig/ holding stand ?
Posted: Sun Oct 23, 22 4:53 pm
Does anyone have a 727 rebuilding stand , or know where I could buy one.
Thanks
Johnny
Thanks
Johnny
- 20221105_195903.jpg (97.42 KiB) Viewed 4010 times
Mopar Muscle Association UK
The premier Mopar club in Europe!
https://www.moparuk.com/forums/
727 rebuilding jig/ holding stand ?
Page 1 of 1
Re: 727 rebuilding jig/ holding stand ?
Posted: Sat Nov 05, 22 8:02 pm
I made one
Re: 727 rebuilding jig/ holding stand ?
Posted: Sat Nov 05, 22 8:13 pm
The one I made supports the trans from the same points. It rotates on the legs so I can have it upright for assembly. You can see it in the foreground.
Re: 727 rebuilding jig/ holding stand ?
Posted: Sat Nov 05, 22 11:01 pm
I've made this , so it will bolt up to my engine stand, and then , as you say I can spin it over or on its ends.
I think it will make rebuilding it a lot easier.
More pics when its on the stand.
I think it will make rebuilding it a lot easier.
More pics when its on the stand.
Re: 727 rebuilding jig/ holding stand ?
Posted: Mon Nov 07, 22 4:30 pm
Job jobbed 
Re: 727 rebuilding jig/ holding stand ?
Posted: Mon Nov 07, 22 5:40 pm
Cool, that works!