Engineering type question

Rebel · Post by **Rebel** » Sun Jun 04, 17 10:55 pm

Super Sloth wrote: This company does some nice stuff.

http://www.imagewheels.co.uk/billet-18-alloy-wheel/

There is some nice stuff on there, but with a nice price as well. I was hoping to spend the same amount on a set of wheels that they're charging for one

andyrob · Post by **andyrob** » Sun Jun 04, 17 11:09 pm

Super Sloth wrote:If you can't get hold of a spacer, what about giving those universal ones a go for mock up? You can then get something machined up locally as a more permanent solution?

Another option might be to go up an inch in rim size?
This company does some nice stuff.

http://www.imagewheels.co.uk/billet-18-alloy-wheel/

I had 8 centrelock wheel made by image, but wasnt entirly happy, looked nice but wernt perfectly round causing virbration at big speeds.

Kev · Post by **Kev** » Mon Jun 05, 17 2:07 am

I thought being round would be the priority for a wheel manufacturer.......

andyrob · Post by **andyrob** » Mon Jun 05, 17 7:52 am

Kev wrote:I thought being round would be the priority for a wheel manufacturer.......

well kev when you ran the car up on the axle stands you could see rim running in and out as if buckled