Does anyone have a 727 rebuilding stand , or know where I could buy one.
Thanks
Johnny
727 rebuilding jig/ holding stand ?
Moderator: Moderators
-
Johnny Dart
- Posts: 852
- Joined: Tue Dec 24, 13 12:46 pm
- Location: East Sussex
-
Johnny Dart
- Posts: 852
- Joined: Tue Dec 24, 13 12:46 pm
- Location: East Sussex
Re: 727 rebuilding jig/ holding stand ?
I made one
- 20221105_195903.jpg (97.42 KiB) Viewed 16883 times
Re: 727 rebuilding jig/ holding stand ?
The one I made supports the trans from the same points. It rotates on the legs so I can have it upright for assembly. You can see it in the foreground.
- Attachments
-
- 24A88781-4AC3-4AD2-A24E-390833090B8A.jpeg (223.32 KiB) Viewed 16882 times
“Buy it broke and fix it wrong, it’s the American way”
-
Johnny Dart
- Posts: 852
- Joined: Tue Dec 24, 13 12:46 pm
- Location: East Sussex
Re: 727 rebuilding jig/ holding stand ?
I've made this , so it will bolt up to my engine stand, and then , as you say I can spin it over or on its ends.
I think it will make rebuilding it a lot easier.
More pics when its on the stand.
I think it will make rebuilding it a lot easier.
More pics when its on the stand.
-
Johnny Dart
- Posts: 852
- Joined: Tue Dec 24, 13 12:46 pm
- Location: East Sussex
Re: 727 rebuilding jig/ holding stand ?
Job jobbed 
- Attachments
-
- 20221107_143357.jpg (103.55 KiB) Viewed 16849 times
Re: 727 rebuilding jig/ holding stand ?
Cool, that works!
“Buy it broke and fix it wrong, it’s the American way”