Front suspension seals

Ivor · Post by **Ivor** » Mon Aug 23, 04 2:11 pm

Can anyone tell me why the rubber seal kits from Year One or Mancini have five track and tie rod seals and one round spongy seal for the idler, when all six should all be the same?

Or am I losing it again?

Alex · Post by **Alex** » Mon Aug 23, 04 2:44 pm

The spongy seal goes where the bolt goes through the frame !

Ivor · Post by **Ivor** » Mon Aug 23, 04 5:00 pm

So that means they all supply one seal short!

there are four seals on the tie rods and two on the drag link, which makes six, if I'm not mistaken.., and as far as a bolt going through the frame Alex, you've got me there.

Good mind to stick the lot in the truck and show you, I'm in your neck of the woods tomorrow!

Alex · Post by **Alex** » Mon Aug 23, 04 5:18 pm

Sure, call round for a brew man !!