Interior plastic trim repair

[Jeff]

Anyone had success with this. $150 for a replacement is a tad harsh! For the missing parts, I have 3D printed the same thickness of plastic with ASA. I am hoping to fuse them together using a 3D pen, (I will have to buy an 3D pen) I will use ASA filament in the pen as well.
Anyone tried this? Or any other methods?

IMG_6358.jpeg (279.73 KiB) Viewed 322 times

[Jeff]

IMG_6387.jpeg (311.23 KiB) Viewed 258 times

It’s all in 1 piece now, should be cured by tomorrow.
Some filling, sanding, re drilling, and painting. And it will be ready to go back on.